Have some of you tested h7500+ or zp810 on WCDMA 900Mhz?

[mke2fs]

Well......It is supported or not...It should never show you "H" if it is not supported, usually WCDMA 900 is used on more remote areas far from populated areas and big towns. In towns they usually use 2100 Mhz.

I will test it myself maybe will go out of town

Ar... this make sense. The screen capture was done at somewhere near my home, which is a remote area(kind of ).

---

Yesterday I tried the 1900 band, that is also shown as supported on the Engineering menu and it didn't work, so I wouldn't hold any hope of getting the 900 band.

I am still wonder how it can show "H" if it works on GSM mode only...

It was running at WCDMA mode(HSPA & HSPA+) as I confirmed it from Engineering mode(Connectivity->CDS->Radio info) when only WCDMA-GSM-900 mode was active during my test.

[bennys1266]

my phone works fine, no any problem.
maybe you should try 3G fix.

[saafi]

my phone works fine, no any problem.
maybe you should try 3G fix.

Which phone you have h7500+ or zp810 ?

You mean no problem for you working on WCDMA 900Mhz?


Cheers.

[poffsoft]

Dear,
i've 3g problem:
If i've enable 3g in settings, the phone goes "out of service" fora long-long time (eg. 10 minutes,), then again connect to network (to gsm and EDGE mode) but after a shotrt time (eg. 1 min) again disconnect and so on.
If i disble the 3g, no out of service happens. If i switch off umts bandg except eg. 850, works good in edge mode (as i expect). But if i enable umts 900 or 2100, out of service again.
I've tried the modem img hanges and the 3g fix also.
(And of course, if i enable 3g in the sort time of "in service" there is some time 3g connection /tested with open signal maps/)

My phone H7500+. my service provider telenorHu ( i'm sure gsm 900/1800; umts 900/2100)

My first phone (h7500+) has no problem with 3g (H,H+) connection, this phone is an exactly same "spare" from factory...
i cannot send back to repair.

So any guess or solution, how can i fix my 3g(2g) problem ?