2015-12-19, 22:58
Hi,
today I got my D6000. It was running on firmware "2.2_abroad" (iirc), and so I thought it a good idea to update. I followed the instructions published in this forum and flashed version 2.7 via QFIL. The download succeeded, but after that it wouldn't start. The screen is dark (no backlight), there is no vibration and no sound, even after letting it sit for 20 minutes.
I can not boot into the recovery, either.
If I press the On-button for 30 seconds, the power consumption (while plugged in, obviously) rises from 0 to about 250 mA. When I plug it then into the computer, it is still recognized by the QFIL flash-tool, and I can download firmwares. I have tried 2.7, 2.6, and 2.5, but nothing got it working again.
As I'm currently looking at a rather expensive brick, any help would be appreciated. Thanks in advance,
Michael
today I got my D6000. It was running on firmware "2.2_abroad" (iirc), and so I thought it a good idea to update. I followed the instructions published in this forum and flashed version 2.7 via QFIL. The download succeeded, but after that it wouldn't start. The screen is dark (no backlight), there is no vibration and no sound, even after letting it sit for 20 minutes.
I can not boot into the recovery, either.
If I press the On-button for 30 seconds, the power consumption (while plugged in, obviously) rises from 0 to about 250 mA. When I plug it then into the computer, it is still recognized by the QFIL flash-tool, and I can download firmwares. I have tried 2.7, 2.6, and 2.5, but nothing got it working again.
As I'm currently looking at a rather expensive brick, any help would be appreciated. Thanks in advance,
Michael