www.chinaphonearena.com

(2014-03-25, 19:21)danyno1 Wrote: [ -> ]

Quote:[quote='danyno1' pid='19253' dateline='1395745004']
here I saw an article before, i think it may helps:
try this and tell me if it worked for you or not

[quote]First of all we need to donwload the “Mobileuncle MTK Tools” from Play Store and switch off the GPS. After that, we can start with

the how-to:

How to fix poor GPS on Mediatek phones

Open the app and press “Engineer Mode”:
[another site]

After that press “Engineer Mode (MTK)”:
[another site]

Once you are in the Engineer mode for MTK devices, you should go to “Location” and then to “Location Based Services”:
[another site]

Now, we tap on EPO and check that “Enable EPO” is enabled and then press on “EPO IDLE”:
[another site]

“EPO IDLE” will change to “EPO DOWNLOADING”, so you will need to wait few minutes to download a file, I suggest that use it with a wifi connection
[another site]

Once EPO DOWNLOADING back again to “EPO IDLE” we can press back and enter into YGPS:
[another site]

In the YGPS you will need to press on “Hot”, “Full” and “AGPS Restart”:
[another site]

Now that you are done test your GPS and you should find that it is faster and more precise!.

have you got any luck with this trick??
[/quote]

Nothing. Satellites aren't found.

I have exactly problem now, no satellites found =/

do you have any nvram back up from the time when everything worked fine?

gps working but is more weak than before

how i can see camera info ? if is 2.0 ?
where i see that?

(2014-03-25, 19:46)danyno1 Wrote: [ -> ]do you have any nvram back up from the time when everything worked fine?

Unfortunately no. I've not. Is it possible to backup your nvram? Do you have inew v3 850/2100 v4.0?

Have you noticed any power consumption improvement?

(2014-03-25, 20:18)jpower73 Wrote: [ -> ]Have you noticed any power consumption improvement?

No, i haven't. But today i've used too much my phone!!

[Only registered and activated users can see links Click here to register]
Well, here is a shot from my gsam monitor

Can someone upload his nvram here?

I have V4 850/2100 version with 1.04 firmware. Do you recommend to install this new version? any battery improvement? i dont know how to read properly your captures of GSam aplication